headphone slot not working

But those are usually few and far between.
This Instructable serves as my journal.
I ran into this today and heres how I fixed it in about a minute.In the future this amp might see slight modifications.It's an interesting trick, but has not presented any problems yet.Taking these steps are a requirement to get the most out of a good pair of headphones.In Boston it is just fine enough that I don't need the shielding, though I do find that sometimes when I place my amp near a large metal object like a fridge with the volume up all the way and no signal source connected (an.Also, a note about the switches: You need a single pole switch for the power but a dual pole switch for the high cut, These are available at Radioshack, but can be ordered from any of the above place for around the same price.But its still effective enough for what we're doing here.I have to say though, I barely ever use this function.But i have found that the lack of shielding has not been that large of an issue.The reason for this is that I wanted the enclosure to be removable from the base in case of repair or modification in the future.
Also, the tube needs heat to operate properly so don't panic about it either if its warm.
Some of the parts I took from the Imagineering Lab to cut down on cost.
Overall I found this a satisfying build.Besides, the build guide Rogers complied is excellent.And now that I have a good source and amp, I can now easily tell the difference in clarity and accuracy between my Grados and Klipsch S4 earbuds (Which as earbuds go are very good).The corners of the enclosure itself on the bottom were still a little curved t slot warped, but they are concealed by the base, which printed straight.Three-axis G-sensor, built-in rechargeable lithium casino cherokee oklahoma battery microSD memory card slot, micro USB port.These parts, however, are generic type parts that can be ordered just about anywhere.I recommend using the biasing pots because the circuit operates best when biased correctly and this is not guaranteed to happen with a fixed resistance.7 kohm.A good way to do this is to not cut the leads off of the components when soldered in and bend them to where the connections need.However, I am going to provide my modified list of parts that I used.